165,441 members
196 posts
  • alanmackey1
    Contributor - Level 2

    I am having some issues with my controller, a couple of keys don't work, and need to send it in for Warranty repair since I've only had it for a little over a month.  I opened a support ticket back on Jan 11 and have had zero communication from Behringer. Is there any way to get customer support other than this ticket system?

    Thank you.

    0 88
    • alanmackey1

      Never mind. Support just contacted me and they seem to not want to honor the warranty and repair the controller.

      • January 22, 2020
  • sigma

    test test

    0 14
  • jackduk
    Contributor - Level 1

    After sitting on my desk for just a few weeks, I've noticed dust building up on my Deepmind 12D which I'm worried about as their are gaps in the sliders where dust is obviously going to gather. 

    Headed over to Decksavers as Facebook must have heard me mention it and then advertised it on my feed and their covers are tip top. Only thing is, they don't do any for Behringer! 

    Anyone know why? Or if any alternatives are out there that look just as good? 

    0 658
  • sigma

    tesst tet

    0 20
  • SawSquareSine
    Contributor - Level 3

    Hi, can anyone explain how to increase the rate of my RD-8 tempo but keep on time? When I run MS-1 into RD-8, the MS-1 is very fast but the RD-8 is very slow. Any tips would be appreciated!

    0 64
  • Senora_music
    Contributor - Level 2


    I am triying configure Ableton live and Crave with the purpose thaty the velocity of the notes I am sending from ableton affects to crave's velocity.

    In Synth Tool I selected MIDI Velocity from Assing Value. I've been tryng through USB and MIDI port from audi interface but it doesn't work.

    Must I do something with patchbay??

    Thanks a lot

    0 112
    • Senora_music

      Usually the velocity accents the noted played. (you can set the threshold in the synthtool.exe)

      When you route the velocity to the ASSIGN patch you need to patch it to the port you want it to affect.

      • January 21, 2020
Go to page