Statistics

165,422 members
164 posts
  • marianorusso
    Contributor - Level 1
    2019-11-22

    I need to activate warranty support (as required by your Support Request Response (Case: 01.032.712)
       communicating: • current postal address (including City / Postcode / Country) via gabriele jannelli 23 80129 napoli italy
    • Serial number of your item (foto)
    • Proof of purchase * enquire  pdf
    to obtain RMA number and service center.
      do you give me instructions?

    [email protected]
    serial mixer beringer.jfif

    fattura beringher mixer.pdf
    read more...
    0 119
    • marianorusso
      GaryHiggins

      @marianorusso They have stopped putting date code stickers on a lot (if not all) of their products. Your date code would by March 2018 which is the first 4 digits after the S in the serial number.

      • November 21, 2019
  • AyChords
    Contributor - Level 3
    2019-11-10

    I bought a subwoofer THRUTH B2029A (fairly used) on eBay, and after carefully reading the manual and following the voltage selection procedures, I powered on the subwoofer. After awhile (5min) I discovered the woofer was seriously heating, and shut down after some minutes. I thought it was disconnected from the mains but not. I troubleshoot (checked and replaced the fuse) but it was not coming up.
    Later I discovered the toroidal transformer is faulty.
    Now I want to replace the transformer, what’s the specifications I should be looking for.? And what’s the voltage that enters to the PCB of B2029A?

    read more...
    0 202
  • SinisterDamned
    Contributor - Level 1
    2019-10-23

    I have a pair of studio 50 usb monitors. They are out of warranty the shop said. I want to know where I can buy the circuit board for it so to replace on my own to save a few $$$. Yes, I'm cheap. Photo attached from the repair shop.

    74574258_10158984705979745_7607716730076397568_n.jpg
    read more...
    0 132
  • gtcode
    Contributor - Level 2
    2019-09-25

    Hi, I haven't bought a P16-m yet. Will the bracket P16-mb allow the P16-m to be mounted to a high hat stand with the unit facing the drummer at a reasonable angle?

     

    Also I looked online but wasn't able to find any info on the mounting holes. I'd like to devise a custom mounting solution if the bracket won't work, before buying it. Anyone have info on this?

     

    Thanks!

    read more...
    0 175
    • gtcode
      gtcode

      Just answering my own questions. From a photo I found it looks as though the P16-mb will work fine with a High Hat stand.

      • September 25, 2019
  • KingBurton
    Contributor - Level 2
    2019-07-08

    Are thees outputs Hiz only or TRS?

    0 176
  • shiyah
    Contributor - Level 1
    2019-06-04
    0 203
Go to page